Jump to content

Power Checks


Recommended Posts

Im just curious.How often do most of you do pwr. checks? After inspections,every few hours,just when ya feel like it,when the wrench wants one,when the boss wants one.And for all the 206 drivers out there do ya do the vertical 0 airspeed one or the cruise flight one.Just curious.Hope every one is having a good summer!

Link to comment
Share on other sites

  • Replies 29
  • Created
  • Last Reply

Top Posters In This Topic

....every take-off not IMMEDIATELY following the previous landing and once my skids clear that concealed loop of barbed-wire sticking out of the ground. And the TOW hasn't knowingly increased.

 

Hopefully a few experts weigh in here too.

 

100'

Link to comment
Share on other sites

Anytime you come on shift before accepting the machine from the pilot on shift. Sometimes this isn''t possible or practicle, but it should be the first thing you do. This ensures he/she didn''t leave you any nasty suprises or just didn''t realize the machine wasn''t performing.

 

Once the engine passes this initial test, each subsequent flight can be metered against your first few normal hover checks. If you notice the TOT increasing with similar ambient conditions when taking off using 100% then, something''s afoot.

 

I''ll try to do one the day before I shift out also. Just so I don''t get blamed for leaving any nasty surpises for the next guy/gal.

 

I always use the 0 airspeed configuration. Remember anti ice, bleed heater and gen off. And remember to use the appropriate chart for part. sep and reverse scoops or snow baffles if installes.

 

 

 

Regards,

 

Link to comment
Share on other sites

You''ll no doubt get a variety of opinions, Mini, (What! On THIS forum??) but if you''re doing them less frequently than every 25 hours, and if you''re not keeping your own records so you can make comparisons and spot trends, you''re almost wasting your time. This can become even more important in a multi-crew situation but, even if you''re all by your lonesome, avoid ugly surprises when you least need them. Keep on checkin.''

Link to comment
Share on other sites

Much more than a run up Commodore, we're talking a precise set of Turbine measurements (OAT, Alt, Temp, Ng, N2, TOT, Q), plotted on a graph, to determine the output of the engine in relation to factory specs.

We do it monthly, and as Downwash says, you have to watch the trend over time.

 

It's easy in a 407, just cruise at your target Alt at 100 Kts, and let the LapTop computer do the rest...

Link to comment
Share on other sites

Wow, come on guys and girls,there has to be more input than this on such an important issue!!100 ft. what was that all about and what did you really say.Im totaly confused.

Link to comment
Share on other sites

----------------

On 7/10/2003 12:15:48 PM Commodore64 wrote:

 

oh, we call that ''trend monitoring''. The crew to fly her first thing every morning does one during cruise.

 

----------------

The best system out for a "multi aircraft operation" is any type of Health Usage Monitoring System or H.U.M.S.

 

These sytems have been out for years and actually pay for themselves, but most operators are to dumb to use them.

 

Everybody knows the story of the overtemps on start-up and or over torque with an overweight sling load so as not to go into the tree''s, etc.,etc.

 

Enuf said.

 

P.S. The same thing happens with fixed wing on take-off. Trend monitoring will not tell you how many times an engine has been over temped or over torqued, you will only find that out when the turbine blows apart.

Link to comment
Share on other sites

Mini, 100'' must be busy. I think what he was referring to was a practice many pros have of doing at least a form of power check on every t/o where you''ve been shut down or idling a long time or, even for a takeoff right after a landing, if your all-up weight has been increased (like more fuel and load) PLUS you''ve ensured there''s nothing interfering with a safe departure from the surface.

 

Some might consider this a bunch of overkill, but it''s a pretty personal thing and who''s to say what''s too much? As in so many things, better too much than too little.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...